What it does
This command creates and alters Snowflake semantic views and validates their definitions. It works with CREATE and ALTER SEMANTIC VIEW statements and checks semantic-view DDL against Snowflake through the Snowflake CLI.
It is intended for building semantic layer definitions, troubleshooting existing semantic views, and guiding setup of the Snowflake CLI and its connection.
Validation runs through the Snowflake CLI, so the CLI must be installed and connected to Snowflake. The command can guide both the installation and the connection setup.
Limitations and requirements
Requires the Snowflake CLI (snow) to be installed and a connection to Snowflake to be set up before DDL can be validated against Snowflake.
Safety
Our team has not reviewed this resource. Only automated rules checked it; resources with high-risk signals are not published. These are signals, not a guarantee that installing it is safe. Try it in a sandbox project first.
- Runs code or changes an assistant's behaviour
Sources
- AI Templates (aitmpl) first seen 13 Nov 2026 · last seen 17 Nov 2026 · its page on the source · figures reported by the source: aitmpl downloads 117
snowflake-semanticview
Create, alter, and validate Snowflake semantic views using Snowflake CLI (snow). Use when asked to build or troubleshoot semantic views/semantic layer definitions with CREATE/ALTER SEMANTIC VIEW, to validate semantic-view DDL against Snowflake via CLI, or to guide Snowflake CLI installation and connection setup.
As shown on www.aitmpl.com when we last read it